INSTALLATION OF ANIMAL FUEL PUMP

 

THANK YOU FOR PURCHASING THE ANIMAL FUEL PUMP KIT FROM TS RACING, INC.

 

  1. Remove the black top cover from the engine in order to attach the fuel pump to the cover.

 

  1. Drill two holes in the front left corner of the cover (the on/off switch is to the front/side of the cover) and attach the fuel pump securely with the bolts (use the bolts on the fuel pump) and nuts provided.  When you mount the fuel pump, mount so that the vacuum and fuel connectors point toward the driver.

 

  1. Remove the white plug located at the top of the crankcase side cover. Replace with the new white plug provided.

 

  1. Using a piece (6” to 8”) of the clear fuel line provided, attach it from the bottom connector of the fuel pump (on the side with two connectors) to the white plug you installed on the crankcase side cover.

 

  1. Attach a piece of the clear fuel line (provided) from the fuel tank to the inlet on the opposite side (single inlet side) of the fuel pump. (Note the arrows on top of fuel pump)

 

  1. Attach the remaining clear fuel line to the exit side of the fuel pump (see arrows on top of fuel pump). Insert the reducer fitting (provide) to connect the clear fuel line and the yellow fuel line. Attach the yellow fuel line to the brass fitting on the carburetor.

 

PS: DON’T FORGET TO PUT OIL IN YOUR ENGINE

Back to Owners Manuals Index